|
Post by zekemccoy on Jul 26, 2004 2:09:09 GMT -7
Needing to order some bearings, off hand does anyone know the #s for the bearings? Front & rear?
Thank you
|
|
|
Post by tperry2054 on Jul 26, 2004 3:44:54 GMT -7
Zeke,
Use your yellow pages and find a store that sells bearings to jobbers. Any medium to large town should have at least 1. Take the bearings to them and they can replace them for you. Check into replacing them with an upgrade if not too much more expensive. They can sometimes even figure out what the bearing is if the markings are obliterated.
Tom
|
|
fp40
New arrival
Posts: 3
|
Post by fp40 on Jul 27, 2004 10:45:51 GMT -7
There is a Old Hobby Shop in Birmingham,Alabama called Spivey's. He has more old Fox parts than the factory. One drawback he is old and low tech, his phone number is as follows, good luck.
1-205-785-9690
Mike Clark
|
|
|
Post by IskandarTaib on Aug 8, 2004 20:17:55 GMT -7
Boca Bearing has them. The Mark VI has a 15mm shaft, so the bearings are not the same as on the old Mark IV. The Mark VII uses an even bigger shaft. If you're going to buy them locally, make sure you get "C3" clearance bearings.
|
|